Displays or sets the date.
DATE [/T | date]
Type DATE without parameters to display the current date setting and a prompt for a new one. Press ENTER to keep the same date.
If Command Extensions are enabled the DATE command supports the /T switch which tells the command to just output the current date, without prompting for a new date.
For the syntax for the date, which is based on your current location settings, run DATE without any commands. Then simply press Enter to accept the current date, or enter a new one.
© Sembee Ltd. 1998 - 2016.
Reproduction of any content on this web site is prohibited without express written consent. Use of this web site is subject to our terms and conditions.
All trademarks and registered trademarks are property of their respective owners. This site is not endorsed or recommended by any company or organisation mentioned within and is to provide guidance only and as such we cannot be held responsible for any consequences of following the advice given.
Sembee Ltd. is registered in England and Wales at 1 Carnegie Road, Newbury, Berkshire, RG14 5DJ.
Registered company number: 4704428. VAT Number GB 904 5603 43.